IMPORTANT: This device has been tested for Voice using Firmware Version Mobilink-IP-1.2.13-C2P-SDX
Setting up the Topex Mobilink IP

Insert a SIM card into the Mobilink IP by opening the simtray by pressing the small yellow button with (for example) …

IMPORTANT: This guide is NOT a supported device. This guide is intended as a guideline only, and will NOT be updated.
This test was performed using Firmware Version 01.00.04f04 and Bootware Version 00.91. These steps may …

Skills Covered by this Module

What is a PSTN Gateway
What types of PSTN lines can be connected to 3CX PhoneSystem
Which PSTN Gateways are supported by 3CX
Configuring a PSTN Gateway on 3CX PhoneSystem
Configuring a Patton SN-4114 (using …

IMPORTANT: This device has been tested for Inbound and Outbound Fax with the following firmware version: Program – 1.0.3.10; Bootloader – 1.0.0.7; Core – 1.0.0.54; Base – 1.0.0.97
Note: This functionality is intended for use with …

Downgrading or Upgrading the firmware of a Grandstream GXW-4104, GXW-4108 gateway for use with 3CX Phone System for Windows

TFTP stands for Trivial File Transfer Protocol simply because of its simplicity.  It is mainly used for automated file transfers between machines on UDP Port 69.  In a VoIP environment TFTP is used to upload …

Note 1: These devices have been tested for Fax and Voice using firmware ‘Smartware 5.4 Build Series 2009-11-18‘ versions available from http://upgrades.patton.com/submodelselect.asp?model=SmartNode

Configuring Outbound Rules on 3CX PhoneSystem is a very simple affair if you have a single device or service which you deliver calls with – in most cases a single rule will be enough.
But the …

IMPORTANT This device has been tested for Voice using firmware version of “Wed Jun 10 11:53:59 2009”. The guide and template may not work for earlier or later versions of the firmware!
Configuration is a 2 …

Recently we released a ‘prototype’ of a Skype Gateway – 3CX Gateway for Skype 1.0 which was based on an open source component. This allowed you to make and receive calls to Skype users. Using …

This is because the Sangoma NetBorder software is configured for the PSTN side to provide the ringing, so if it is not then you will not hear any ringing.
To fix this issue we must tell …

This is the last part on how to configure the Patton for use as a PSTN gateway for 3CX. Very detailed and highly recommended!

This video has been developed by Marco Liechti of Patton and is the first of three part series about using VoIP gateways with 3CX. It explains why you need a VoIP Gateway and …