[thereverend]

Can someone please help me by providing step by step directions to programming the SPA-303 to work with 3CX.. i can get into the web page to admin the phone but need to know what setting and where to put the 3CX server info..

Please help thanks

[willow]

you will need to setup the sip server ip address, user name, id, password and that is the basics.

[thereverend]

I do not see anywhere to put he SERVER IP the screens do not show this and I DO have admin access. It is in SIP mode but can not find this.. Can you please tell me where to find it..

[eagle2]

It is quite similar to old SPA-941 in settings (see manual provisioning) or new SPA-504 (again manual provisioning).
Nothing specific. Just go to: http://<SPA-303_IP_address>/admin/advanced and configure the same way.

regards

[thereverend]

It is quite similar to old SPA-941 in settings (see manual provisioning) or new SPA-504 (again manual provisioning).
Nothing specific. Just go to: http://<SPA-303_IP_address>/admin/advanced and configure the same way.

regards

I am not seeing any place for me to put the 3cx server address in.. Can you possibly provide a screen shot or two.. I also do not see anywhere to put the ID and PW for the account either..

[eagle2]

I don't have available SPA-303 at present.

You need to log as admin in advanced mode to see all the settings. Select Ext 1 tab.

I'm attaching a screen-shot from SPA-502G - it is quite similar.

SPA-502G

new-1.jpg (83.21 KiB) Viewed 1189 times

[thereverend]

Ok.. I got into the area and set the PROXY to my 3cx server IP and gave it an extension ID an PASSWORD but.. when the phone re boots its on a YELLOW status on the phone and when you try to make a call it says 404 FAILED. can you tell me why it is doing that>??? thanks

I don't have available SPA-303 at present.

You need to log as admin in advanced mode to see all the settings. Select Ext 1 tab.

I'm attaching a screen-shot from SPA-502G - it is quite similar.

new-1.jpg

[thereverend]

Thank you everyone for the help. I got it.. there was a hidden field called PROXY OUTGOING that was not there till i hit the advanced tab... Thanks again everyone!