[serverx]

Hello,
I bought a new linksys spa-3102 and i followed the instruction at http://www.3cx.com/voip-gateways/linksys-3102.html (first step) to configure the spa-3102 as gateway to route all the pstn calls to 3cx extensions or IVR.
Actually i can see from 3cx "Ports/Trunks Status" that the gateway is connected to 3cx system but the calls aren't routed to 3cx extensions.
When a PSTN inbound call rings only the analog phone which is connected to line 1 of gateway spa-3102 rings, but not calls aren't routed to 3cx extension.
I setup the In 3CX, i have routed the pstn port (10007) inbound calls to the extensions "Connect to the Digital Receprionist" but it doesn't work, i tried to route to normal extension too but same result.
I'll be appreciate that if I can get some help about this problem.

Thanks

[leejor]

There is an option in the PSTN tab...PSTN ring thru line 1, that should be set to no. Change that and see how it goes.

[serverx]

thank u so much for reply...... i set "PSTN Ring Thru Line 1: no"
but same result..... the call not forwarded to 3cx extensions...
what it can be ?

Thanks

[leejor]

Does the call show up in the 3CX server logs? If it doesn't then it is a setting in the 3102 (double check your settings, especially dialplan 8 ), if it does, then it is a setting in 3CX, in which case the log may give you some hints as to why it is not reaching the intended destination(s).

[hainesk967]

I'm having the same issue. Any update on if/how you got this fixed?

[hainesk967]

I figured it out. Turns out I needed to plug the network cable into the Internet port instead of the ethernet port, and set the WAN IP to address I want on my network instead of the lan ip.

[leejor]

They didn't do the best job in labelling that device, even "WAN" and "LAN" would have been better. The black letters on a dark background doesn't help either.