Configuring Vegastream Europa 50 (2 x BRI) VOIP Gateway for 3CX Phone System

IMPORTANT This guide has been tested with the 13.02.08.2 S035 R8.2 firmware version. The guide and template may not work for earlier or later versions of the firmware!

Configuration is a 2 step process. First you configure 3CX Phone System for use with the Vegastream. 3CX Phone System will then output a configuration file for you to upload to the Vegastream device.

Step 1:  Configuring 3CX Phone System to work for use with Vegastream Europa 50

  1. Log on to the 3CX Phone System Management Console and go to:
    Lines => Add PSTN
     
  2. Assign a name to the device, such as: VegaEur50
  3. Click the “Next >" button
     
  4. From the “Country” drop-down menu, select the Country Tone Set that most closely matches that in use by the Telecoms Provider.
  5. From the “Connection Type” drop-down menu, select whether this is a Point-To-Point or Point-To-Multipoint connection (refer to information given by your Telecomms Provider).
  6. Click the “Next >” button
     
  7. In the field “Gateway Hostname or IP”, insert the IP Address that you would like the device to use when connected to the LAN for communication with 3CX Phone System. Note that the Vegastream Europa 50 and the 3CX Phone System must reside inside the same LAN. In our example: 172.18.130.4
  8. The “Number of ports” field is set by default to the number of ports available in the device. If this value is changed, it will not be possible to generate the configuration file.
  9. Click the “Next >” button
  10. The “Create Lines” page allows you to configure each channel’s parameters, namely:
    a. Virtual Extension Number
    b. Authentication ID
    c. Authentication Password
    d. Number of simultaneous calls that the channel can handle
    e. Direction of calls that will be allowed by the channel
    f. The Identification (External Number) of the channel
    g. The destination of calls that are received by the channel
    These values are pre-populated, but may be changed at this point. The configuration file will be generated using the parameters supplied in this page.
  11. Click the “Next >” button   

  12. The “Create Outbound Rule” provides a quick and easy way to correctly configure a simple rule to allow outbound calls using the Vegastream Europa 50 device to deliver outbound calls. By default, the Prefix to use this rule will be “0”, and all extensions will be able to dial outbound via this rule. These values are pre-populated, but may be changed at this point.
  13. Click “Finish” (or “Skip” if you do not want to create an outbound rule).

  14. The 3CX Phone System is now fully configured for the Vegastream Europa 50. You can now click the “Generate config file” button to save to disk a file that will automatically configure the device with the settings provided above.   

Step 2: Connect the Europa to the network and upload the Configuration file

The next step is to connect the Europa to the network and upload the 3CX Phone System generated configuration file. Please see this FAQ how to do this.

VOIP Gateway Configuration Guides