garn
Customer
- Joined
- Jul 17, 2017
- Messages
- 24
- Reaction score
- 2
Coming back around to this thread - https://www.3cx.com/community/threads/yealink-v82-firmware-and-park.56156/#post-233629
I've finally had the time to tackle this and have spent hours slipstreaming my template with the latest version template and testing various combinations and have had no success.
I finally just exported the full .cfg from my phone in each provisioned state, each after a full factory reset. One on the default template, one on my template.
One or both of these two settings appear to be the culprit that show on the phones config on my template but not on the default:
features.call_park.park_mode = 0
bw.enable = 1
Interestingly enough, neither of these settings are correctly reflected according to my template. The first I actually have set to option 2, and the last is not stated at all.
Quite annoying! So something is overriding my template to ignore the first setting, and causing the second setting to also be applied.
I've finally had the time to tackle this and have spent hours slipstreaming my template with the latest version template and testing various combinations and have had no success.
I finally just exported the full .cfg from my phone in each provisioned state, each after a full factory reset. One on the default template, one on my template.
One or both of these two settings appear to be the culprit that show on the phones config on my template but not on the default:
features.call_park.park_mode = 0
bw.enable = 1
Interestingly enough, neither of these settings are correctly reflected according to my template. The first I actually have set to option 2, and the last is not stated at all.
Quite annoying! So something is overriding my template to ignore the first setting, and causing the second setting to also be applied.