Dismiss Notice
We would like to remind you that we’re updating our login process for all 3CX forums whereby you will be able to login with the same credentials you use for the Partner or Customer Portal. Click here to read more.

3CX 11 new install, auto-provisioning polycom 501

Discussion in '3CX Phone System - General' started by npereira, Aug 7, 2012.

Thread Status:
Not open for further replies.
  1. npereira

    Jan 5, 2009
    Likes Received:
    Hi all,

    searched the forum for this but was not able to resolve.

    I have 50% of my userbase using 501's and currently on a Asterisk. I'm testing 3CX.

    I looked at the sip_31x.cfg in the provision folder and it stated to take the sip.ld and copy it to the povision folder as well as rename it to sip_31x.ld which i did.

    I then factory reset my 501 and changed the settings to be http.

    My Linux dhcp server has :

    host test-501-extension {
    hardware ethernet 00:04:f2:1c:e6:d6;
    option tftp-server-name "";

    yes the phone boots up, loads app = sip_31x.ld and at the point where it should load the config, it stops and says confid file error error is 0x20 then proceeds to reboot.

    Can anyone shed some light on this?

    Greatly appreciated.
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  2. lneblett

    lneblett Well-Known Member

    Sep 7, 2010
    Likes Received:
    take a look at the following:

Thread Status:
Not open for further replies.