3CX and NIC Teaming

Discussion in '3CX Phone System - General' started by dkeeler, Jan 7, 2014.

Thread Status:
Not open for further replies.
  1. dkeeler

    Joined:
    Nov 8, 2011
    Messages:
    4
    Likes Received:
    0
    I was wondering if anyone has setup 3CX on a teamed NIC setup. Should this cause any issues?
     
  2. bardissi

    bardissi Member

    Joined:
    Jan 31, 2012
    Messages:
    318
    Likes Received:
    0
    As long as the teamed NIC has a single IP I dont see why you should have an issue.
     
  3. sigma1

    sigma1 Active Member

    Joined:
    Nov 20, 2009
    Messages:
    542
    Likes Received:
    1
    Teaming always implies the use of one IP address, either in fail over or aggregation. If you MUST do this, use LACP. We use Intel NIC for this or Broadcom, the driver itself allows you to select the desired setup (either for redundancy perhaps one card in one switch and one in another) - THIS IS NOT LACP - or if you think that you need more than the 1Gbps that you currently have use a switch that support LACP, configure 2 ports as an LACP group and then connect it to your server. Do not try this is your switch does not support it. You should have no problem at all.
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
Thread Status:
Not open for further replies.