3CX SIP Proxy Manager documentation

Discussion in '3CX Phone System - General' started by pdq, Jul 15, 2010.

Thread Status:
Not open for further replies.
  1. pdq

    pdq

    Joined:
    Dec 3, 2009
    Messages:
    82
    Likes Received:
    0
    Can we standardize the documentation for using the 3CX SIP Proxy Manager at :
    http://www.3cx.com/blog/releases/sip-proxy-manager/ ?
    Specifically:
    1. Can for screenshots of the SIP Proxy Manager show the same IPs and what is up with 0.0.0.0?
    2. I see three different WAN IPs and does not follow the parts about Typical Scenario and Assumptions and the discussion below use those IP addresses.

    I am attempting to make this work with a Cisco 503G and trying to decrypt which Ip is where is a challenge. Thanks
     
  2. mfm

    mfm Active Member

    Joined:
    Mar 4, 2010
    Messages:
    641
    Likes Received:
    2
    Hi,

    The 0.0.0.0. is the network card that you are going to use as the proxy, for other phones to connect to. I have forwarded your request.
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  3. pdq

    pdq

    Joined:
    Dec 3, 2009
    Messages:
    82
    Likes Received:
    0
    Then is should show the same IP address as the proxy screen shot above it.

    0.0.0.0 is not a valid IP
     
Thread Status:
Not open for further replies.