- Joined
- Oct 28, 2007
- Messages
- 181
- Reaction score
- 0
Has any one setup a 3cx-to3cx-bridge yet?
Also, where is the open VPN client and server settings?
If I setup a Extention on 3CX A and use the same extention as a Voip Provider on PBX B, it does work.
But when I setup a 3cx-to3cx-Bridge, it does register but when dialling the remote branch prefix and number, it says on the phone display: Temporarily unavailable after 2 sec of silence
23:44:02.015 Call::Terminate [CM503008]: Call(14): Call is terminated
23:44:01.953 Call::RouteFailed [CM503014]: Call(14): Attempt to reach [sip:[email protected];user=phone] failed. Reason: Server Failure
23:44:01.953 CallLeg:nFailure [CM503003]: Call(14): Call to sip:200:5060 has failed; Cause: 503 Service Unavailable; warning: ; internal
23:44:01.859 CallCtrl:nSelectRouteReq [CM503004]: Call(14): Calling: PBXline:10019@[Dev:sip:10019:5060]
23:44:01.796 CallCtrl:nIncomingCall [CM503001]: Call(14): Incoming call from Ext.210 to [sip:[email protected];user=phone]
Also, where is the open VPN client and server settings?
If I setup a Extention on 3CX A and use the same extention as a Voip Provider on PBX B, it does work.
But when I setup a 3cx-to3cx-Bridge, it does register but when dialling the remote branch prefix and number, it says on the phone display: Temporarily unavailable after 2 sec of silence
23:44:02.015 Call::Terminate [CM503008]: Call(14): Call is terminated
23:44:01.953 Call::RouteFailed [CM503014]: Call(14): Attempt to reach [sip:[email protected];user=phone] failed. Reason: Server Failure
23:44:01.953 CallLeg:nFailure [CM503003]: Call(14): Call to sip:200:5060 has failed; Cause: 503 Service Unavailable; warning: ; internal
23:44:01.859 CallCtrl:nSelectRouteReq [CM503004]: Call(14): Calling: PBXline:10019@[Dev:sip:10019:5060]
23:44:01.796 CallCtrl:nIncomingCall [CM503001]: Call(14): Incoming call from Ext.210 to [sip:[email protected];user=phone]