Dismiss Notice
We would like to remind you that we’re updating our login process for all 3CX forums whereby you will be able to login with the same credentials you use for the Partner or Customer Portal. Click here to read more.

3CX V11 and Patton 4114

Discussion in '3CX Phone System - General' started by pebble1, Apr 15, 2013.

Thread Status:
Not open for further replies.
  1. pebble1

    Joined:
    Nov 3, 2009
    Messages:
    1
    Likes Received:
    0
    Everything was working and I decided to update the Firmware of the Patton from 4.2 to 6.3. Now I cannot make calls. It shows the trunks registered and I can receive incoming calls fine. When I try placing a call I see 0/1 go active for 15 seconds then it tries 0/1 and on until it fails and gives a busy signal.

    The Log shows: "Call or Registration to 8283367688@(Ln.10000@Patton 4114 4xFXO) has failed. [ V4 192.168.50.21:5066 UDP target domain=unspecified mFlowKey=868 ] replied: 502 Bad Gateway; from IP:192.168.50.21:5066"

    I did create a new config file and same result.
    It worked before upgrade, I tried rolling back to 4.2 but it does not work either.
     
  2. kevin

    kevin Member

    Joined:
    Nov 23, 2006
    Messages:
    316
    Likes Received:
    1
    @pebble1

    The response "502 Bad Gateway" typically means that the POTS line is faulty in some way (maybe not connected). Port number 5066 indicates (typically) the 4th port - is there a line connected to port 4?
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
Thread Status:
Not open for further replies.