Audiocodes MP114

Discussion in '3CX Phone System - General' started by MB1, Nov 24, 2011.

Thread Status:
Not open for further replies.
  1. MB1

    MB1

    Joined:
    Nov 2, 2007
    Messages:
    39
    Likes Received:
    0
    Incoming call hears a dial tone for a number of seconds before the extension rings.
    When I changed the MP114 values for Dial Tone Duration [sec] Dial Tone Duration [sec] to '0'
    (DTMF and Supplementary > DTMF & Dialing Dial Tone Duration [sec] Dial Tone Duration [sec]), incoming calls are routed seamlessly (no dialtone and straight to ring tone). The problem is with this setting there is no dial tone for outbound calls.

    Any ideas?
     
Thread Status:
Not open for further replies.