Auto callback Option

Discussion in '3CX Phone System - General' started by Jpaudio, Sep 18, 2014.

Thread Status:
Not open for further replies.
  1. Jpaudio

    Joined:
    Sep 18, 2014
    Messages:
    2
    Likes Received:
    0
    Hi everybody,

    I am currently trying to enable the auto callback function for my assistance center.

    On the call recording it gives me the option to press * to request a callback.

    When the extension starts to ring I pick it up, it should auto dial which it doesn't.

    I have set up a outbound rule, but it either drops out straight away or it goes to hold tone and doesn't call out.

    Any ideas? The outbound prefix matches both the queue and the outbound rule.

    Is there instructions anywhere on how to set this up?

    Thanks
    Julian
     
  2. pj3cx

    pj3cx Active Member

    Joined:
    Aug 1, 2013
    Messages:
    645
    Likes Received:
    1
    Hi there,
    What are the outbound rule criterias set? only prefix or anything else?
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  3. Jpaudio

    Joined:
    Sep 18, 2014
    Messages:
    2
    Likes Received:
    0
    Tried all diff prefix, any suggestions?
     
  4. pj3cx

    pj3cx Active Member

    Joined:
    Aug 1, 2013
    Messages:
    645
    Likes Received:
    1
    You should have a rule with prefix or number length criterias only, no criterias on extension/group of extension, is that the case?
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
Thread Status:
Not open for further replies.