Solved Auto provision changes admin pwd on Yealink phones

Discussion in '3CX Phone System - General' started by rancho, Nov 5, 2017.

Thread Status:
Not open for further replies.
  1. rancho

    Joined:
    Jun 14, 2011
    Messages:
    25
    Likes Received:
    2
    Testing a Yealink T46S and two Yealink T21P E2 phones prior to deployment. Testing against my 3CX NFR installation.

    After provisioning through the management console (RPS) the process changes the admin password.

    I did find an answer that worked for the T46S at https://www.3cx.com/community/threads/auto-provision-changes-admin-pwd-on-yealink-t20.39924/ but this did not work for the T21P E2 phones. I searched the 3CX forum for other posts regarding this issue and found no help there.

    This is not addressed in the training.
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  2. rancho

    Joined:
    Jun 14, 2011
    Messages:
    25
    Likes Received:
    2
    Issue resolved. Needed to set the desired PW from the Phones --> Selected Extension --> Edit --> Provisioning tab.
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  3. YiannisH_3CX

    YiannisH_3CX Support Team
    Staff Member 3CX Support

    Joined:
    May 10, 2016
    Messages:
    4,443
    Likes Received:
    282
    Glad the issue is resolved and thank you for sharing your solution
     
Thread Status:
Not open for further replies.