Dismiss Notice
We would like to remind you that we’re updating our login process for all 3CX forums whereby you will be able to login with the same credentials you use for the Partner or Customer Portal. Click here to read more.

Auto vs manual provision - exting config - Snom 370

Discussion in 'Windows' started by wizards, May 29, 2010.

Thread Status:
Not open for further replies.
  1. wizards

    Mar 30, 2010
    Likes Received:
    I have a Snom 370 already provisioned to an Epygi PBX which I need to keep. But I'd like to use one of the remaining seven "ID" channels on the Snom to *also* register it as an extension on the 3CX.

    If I fill in the MAC address and phone type, I assume 3CX will "grab" the phone and over-write the existing config. Is there any way I can tell the auto-prov mechanism to leave ID1 alone and program ID2 instead? Or will I have to go manual?

    (I'm surprised there isn't more info on this as almost all "posh" brands of phone support multiple connections.)
Thread Status:
Not open for further replies.