BLFs on SPA504G

Discussion in '3CX Phone System - General' started by Rodolfo, Oct 18, 2012.

Thread Status:
Not open for further replies.
  1. Rodolfo

    Joined:
    Oct 18, 2012
    Messages:
    1
    Likes Received:
    0
    System was running fine on V10.
    Then moved to V11 (backup, uninstall V10, install V11, restore).
    Everything went fine. System is running OK.
    Problem: BLFs with assigned direct calls are now blinking ambar (but working fine).
    Try to play with the provisioning template but no look.
    Disabling provisioning will fix the blinking (but still is ambar).
    Same situation with an SPA502G + 500S sidecar.
    Any clues?
    Thanks in advance
     
  2. infonetics

    Joined:
    Sep 13, 2011
    Messages:
    41
    Likes Received:
    0
    I ran into this when I upgraded to the 7.5.3 firmware. Had to downgrade back to 7.5.1a, I think it's the latest that is supported by 3CX.
     
  3. mixig

    mixig Active Member

    Joined:
    Dec 13, 2011
    Messages:
    519
    Likes Received:
    11
    There is also a topic with the same story

    http://www.3cx.com/forums/spa50x-fw-7-5-2a-7-5-3-fyi-31639.html
     
  4. StefanW

    StefanW Head of Customer Support and Training
    Staff Member 3CX Support

    Joined:
    Jun 2, 2009
    Messages:
    1,186
    Likes Received:
    77
    it will be fixed in SP2 to match the latest FW of cisco.
    You can have a go with this pre template of mine
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
Thread Status:
Not open for further replies.