Call Disconnect problem

Discussion in '3CX Phone System - General' started by elewis, Jun 18, 2008.

Thread Status:
Not open for further replies.
  1. elewis

    Joined:
    May 16, 2008
    Messages:
    5
    Likes Received:
    0
    Hi,

    I just downloaded version 6 of 3CX (free version)for evaluation/testing. I have two SIP devices that automatically call and receive. This works fine, but even if I disconnect the devices the call stays active. When I try to disconnect the call in the management console I get a message stating that the the "PBX does not accept your request or you don't have a license".
    Is there a license associated with the free version or do I have to pay for this 'feature'?

    Thanks
     
  2. elewis

    Joined:
    May 16, 2008
    Messages:
    5
    Likes Received:
    0
    Thank you. That key worked, although I am now limited to two simultaneous calls vs. 8.
     
  3. elewis

    Joined:
    May 16, 2008
    Messages:
    5
    Likes Received:
    0
    Thanks Matt. I will use the two phone version! :lol:

    It is much appreciated. I amy call back after everything is tested for the enterprise version.
     
Thread Status:
Not open for further replies.