Camrivox Flexor 500 Phone

Discussion in '3CX Phone System - General' started by nigelainscoe, Feb 2, 2008.

  1. nigelainscoe

    Joined:
    Feb 2, 2008
    Messages:
    4
    Likes Received:
    0
    This is my first foray into IP telephony. I have signed up with sipgate and the 3CX server has registered itself with that OK.

    I have bought a Camrivox Flexor 500 Phone as it is well specified and seemed a good buy. Now I am struggling to get it to connect to the 3CX software. Has anyone any experience of using one of these phones

    Regards,
    Nigel Ainscoe

    This is the phone spec if it is any use:
    IVoice Algorithms and Protocols

    * SIP, RTP, SDP
    * UDP, TCP and TLS supported
    * VAD - Voice Activity Detect
    * CNG - Comfort Noise Generation
    * Jitter Buffer - Adaptive
    * Packet Loss Compensator
    * International Call Progress Tone generator
    * DTMF: In-band and Out-of-band (RFC2833)
    * Caller ID support (Name and Number)
    * Call Waiting Indicator tone
    * Message Waiting Indicator tone
    * G.711, G.726, G.729

    Networking

    * DHCP client, DNS client
    * ICMP, TCP/UDP/IP
    * STUN
    * SNTP
    * HTTP/HTTPS
    * RIP and RIPv2

    Quality of Service (QoS)

    * 802.1Q
    * Type of Service (ToS)
    * Pacing and prioritization of voice data
    * VLAN (802.1pq)
     
  2. Nick Galea

    Nick Galea Site Admin

    Joined:
    Jun 6, 2006
    Messages:
    1,731
    Likes Received:
    41
    You should use a 3CX supported phone - see our support page for this list.
     

Share This Page