Change HTTPS port after installation?

Discussion in '3CX Phone System - General' started by robxbl69, Apr 7, 2015.

Thread Status:
Not open for further replies.
  1. robxbl69

    Joined:
    Jun 8, 2013
    Messages:
    24
    Likes Received:
    4
    When I upgraded from 12.0 to 12.5 I kept with 5000/5001, but now I'm using WebRTC I'd like to change 5001 to 443.

    I enabled the Abyss console and change it to 443 and whilst the management console works fine on 443, WebRTC is still expecting to be on 5001.

    Where do I need to change the port number in 3CX?

    Thanks, Rob.
     
  2. robxbl69

    Joined:
    Jun 8, 2013
    Messages:
    24
    Likes Received:
    4
    In the end I resorted to a backup and restore and chose 443 during install. Left http on 5000.

    Only one issue was that even through I chose to backup SSL certificate(s), it didn't back up the CA signed certificate I'd added to Abyss for WebRTC, so I had to reinstall manually afterwards.
     
Thread Status:
Not open for further replies.