Dismiss Notice
We would like to remind you that we’re updating our login process for all 3CX forums whereby you will be able to login with the same credentials you use for the Partner or Customer Portal. Click here to read more.

Cisco 1751 configuration and call transfer.

Discussion in '3CX Phone System - General' started by Urbok, Nov 25, 2007.

Thread Status:
Not open for further replies.
  1. Urbok

    Urbok New Member

    Joined:
    Jul 14, 2007
    Messages:
    120
    Likes Received:
    0
    hello cisco experts :).
    I've correctly installed and configured a 2 port wic fxs card of my cisco 1751.
    now I've 2 extensions working great.

    my big problem now it's call transfer.
    How do I transfer a call from extension to another extension?

    PS on port 2/0 i've connected a fax. on 2/1 a standard analog phone.

    here is the voip configuration on cisco router:

    voice-port 2/0
    no vad
    cptone IT
    timeouts wait-release 15
    bearer-cap Speech
    station-id number 1003
    caller-id enable
    !
    voice-port 2/1
    input gain -6
    output attenuation -6
    no vad
    cptone IT
    timeouts wait-release 15
    bearer-cap Speech
    station-id number 1004
    caller-id enable
    !
    !
    !
    !
    !
    !
    dial-peer voice 1003 pots
    destination-pattern 1003
    fax rate fax
    port 2/0
    authentication username 1003 password XXX
    !
    dial-peer voice 1004 pots
    destination-pattern 1004
    port 2/1
    authentication username 1004 password XXX
    !
    dial-peer voice 10000 voip
    destination-pattern .T
    session protocol sipv2
    session target ipv4:192.168.25.101
    dtmf-relay rtp-nte
    codec g711ulaw
    fax rate 14400
    fax protocol pass-through g711alaw
    !
    gateway
    timer receive-rtp 1200
    !
    sip-ua
    registrar ipv4:192.168.25.101 expires 3600
    sip-server ipv4:192.168.25.101
    !
    !
     
  2. ITWorks

    ITWorks New Member

    Joined:
    Apr 7, 2007
    Messages:
    121
    Likes Received:
    0
    transfer

    Urbok,

    I am inclined to think this is not a Cisco router issue, but rather a function of the phone. Also not sure but I would think the analog phone would need to send a transfer signal that could be translated to a SIP signal. Does the analog phone have a transfer function? Can you do a "debug dialer" to see what happens when you use the function?

    Mark
     
  3. alicic

    alicic New Member

    Joined:
    Oct 3, 2007
    Messages:
    119
    Likes Received:
    0
    Hallo,

    If your pfones support call transwer then it should be configured in cisco as follows

    conf t
    telephony-service
    transfer-system full-consult
    transer-pattern .T

    it should then transwer the calls,

    regards
     
  4. Urbok

    Urbok New Member

    Joined:
    Jul 14, 2007
    Messages:
    120
    Likes Received:
    0
    what do you mean for "pfones"??
    my phones are standard analog cordless with "R" flash key.

    with other ata adapters to transfer a call I do "R" + extension.

    with cisco the flash key do nothing.
     
Thread Status:
Not open for further replies.