Cisco router 1800 - Range port forwarding

Discussion in '3CX Phone System - General' started by xylogistix, Jan 10, 2017.

Thread Status:
Not open for further replies.
  1. xylogistix

    Joined:
    Jul 28, 2011
    Messages:
    39
    Likes Received:
    3
    I am trying to config port Forwarding for a range of 3CX Ports on Cisco 1800 series router with no sucess.
    Please see my last attempt below

    ip nat inside source route-map 3CX_NAT_MAP interface FastEthernet0/1 overload
    ip nat pool 3CX_POOL 192.xxx.xxx.xxx 192.xxx.xxx.xxx netmask 255.255.255.0 type rotary
    ip nat inside destination list DEST_LIST pool 3CX_POOL
    !
    ip access-list extended DEST_LIST
    permit tcp any any range 5000 6000
    permit udp any any range 9000 9500

    FasterEthernet0/1 is my interface with Public IP

    Anybody out there with a better easy way?

    Regards
     
  2. xylogistix

    Joined:
    Jul 28, 2011
    Messages:
    39
    Likes Received:
    3
    Anybody out there to help?
     
Thread Status:
Not open for further replies.