Dismiss Notice
We would like to remind you that we’re updating our login process for all 3CX forums whereby you will be able to login with the same credentials you use for the Partner or Customer Portal. Click here to read more.

Cisco SPA514G requesting Yealink firmware upon boot

Discussion in '3CX Phone System - General' started by cpontus, Apr 30, 2014.

Thread Status:
Not open for further replies.
  1. cpontus

    Joined:
    Feb 17, 2012
    Messages:
    42
    Likes Received:
    0
    At one point my users were on Yealink phones. I am switching them over to Cisco phones. All I did was choose the new phone type and reprovision. Everything works fine but I get this in my syslog from the phone when it boots:

    Wed Apr 30 05:53:38 2014: <134>SPA514G a4:93:4c:xx:xx:xx -- Requesting upgrade http://192.168.1.8:5000/provisioning/xxxxxxxx/firmware/cisco/38.70.0.168.rom
    Wed Apr 30 05:53:38 2014: <134>SPA514G a4:93:4c:xx:xx:xx -- Upgrade failed: file not found

    As you can see the firmware filename is that of a Yealink T38G. Any ideas?

    I'm on 3CX 12 SP4.
     
  2. cpontus

    Joined:
    Feb 17, 2012
    Messages:
    42
    Likes Received:
    0
    Anyone? I'm sure there is some configuration stuck somewhere but I don't know where it could be.
     
Thread Status:
Not open for further replies.