CODEC selection for bridge calls

Discussion in '3CX Phone System - General' started by andrewrobinson, Mar 23, 2009.

Thread Status:
Not open for further replies.
  1. andrewrobinson

    Joined:
    Mar 23, 2009
    Messages:
    1
    Likes Received:
    0
    I've recently been configuring bridge mode between two 3CX V7 servers and although I can get them talking to each other and routing calls correctly the CODEC selection doesn't appear to work properly.

    If I configure the bridge to use the GSM codec and make a call between two extensions connected to different servers it uses the G.711 codec as configured on the 3CX VoIP softphones and not the GSM codec as configured on the bridge.

    Have I got something wrong in the configuration somewhere?
     
Thread Status:
Not open for further replies.