configuring max. call duration limit

Discussion in '3CX Phone System - General' started by valentia1, Feb 24, 2012.

Thread Status:
Not open for further replies.
  1. valentia1

    Joined:
    Jan 27, 2012
    Messages:
    2
    Likes Received:
    0
    hello guys,
    I'm a newbie to 3cx, so pardon me if i'm asking a obvious question.
    Is there any way we can setup a max. call duration time so that the call gets disconnected automatically if it exceeds the defined time limit. i'm talking about incoming calls.

    regards,
    sufian
     
  2. leejor

    leejor Well-Known Member

    Joined:
    Jan 22, 2008
    Messages:
    10,375
    Likes Received:
    231
    This is usually a function handled by a gateway.
     
  3. valentia1

    Joined:
    Jan 27, 2012
    Messages:
    2
    Likes Received:
    0
    itdoesn but i want to add feature for all calls going to/from my PBX not only a specific gateway........want this even for local calls within pbx.
     
  4. leejor

    leejor Well-Known Member

    Joined:
    Jan 22, 2008
    Messages:
    10,375
    Likes Received:
    231
    In a normal office environment there isn't a lot of call for cutting off a conversation after a given time, in fact it would be very undesirable. I could understand the desire for this feature if you were had some sort of re-seller service, offering time limited phone calls, to customers. That really isn't the intended function of 3CX. Perhaps someone else has come up with a "work around".
     
Thread Status:
Not open for further replies.