Configuring Sangoma PRI

Discussion in '3CX Phone System - General' started by steveh, Mar 29, 2009.

Thread Status:
Not open for further replies.
  1. steveh

    Joined:
    Feb 19, 2009
    Messages:
    6
    Likes Received:
    0
    Hi,
    I'm planning to order a SANGOMA A102 card for the 3cx setup with PSTN.
    This card have two PRI ports.
    When I start the configuration wizard for the card in "Add PSTN Gateway" i see the option to configure 1 port only.
    Does anyone knows if a two port SANGOMA card is supported? if so how do I configure it? do I simply create an addtional VOIP GW for the second port?

    Thanks
     
  2. 5qg4

    5qg4 Active Member

    Joined:
    Jan 31, 2007
    Messages:
    643
    Likes Received:
    0
    You status just plan to order a SANGOMA A102 card for the 3cx. If not the budget issue, I would like to suggest you to order Patton SN496X instead. Since most success case are using Patton. And 3CX also recommended Patton as well.
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  3. discovery1

    discovery1 Member

    Joined:
    Aug 4, 2008
    Messages:
    355
    Likes Received:
    0
    Did you read the 3CX documentation for the supported Sangoma cards?
    By the looks of things only the A200 and PRI cards are supported.

    http://www.3cx.com/voip-gateways/ - UPDATED LINK
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  4. steveh

    Joined:
    Feb 19, 2009
    Messages:
    6
    Likes Received:
    0
    Hi,
    Looking at 3cx configuration guides they do support Sangoma A101 T1/E1/J1
    I don't see the A102 there, this card have two E1 ports.
    I need to know if it is supported as well or should I get two A101 cards.
    I do have a budget problem so Sangoma card is failry less expensive.

    Thanks
     
Thread Status:
Not open for further replies.