Dismiss Notice
We would like to remind you that we’re updating our login process for all 3CX forums whereby you will be able to login with the same credentials you use for the Partner or Customer Portal. Click here to read more.

Dial Codes

Discussion in '3CX Phone System - General' started by jasonhayes, Jun 13, 2012.

Thread Status:
Not open for further replies.
  1. jasonhayes

    jasonhayes New Member

    Joined:
    May 9, 2012
    Messages:
    140
    Likes Received:
    10
    I'm using some old AVAYA 4610SW IP phones on the 3CX software. All is good except, I cannot use Dial Codes. The phone will not pass them on, partly I think because the phones trying to use them a Feature codes.

    So my question do Dial Codes within 3CX have to start with a * (star), can they be # (gate), then the code? EG #0, rather than *0 to park a call?
     
  2. mixig

    mixig Active Member

    Joined:
    Dec 13, 2011
    Messages:
    530
    Likes Received:
    12
    I get this when trying change *0 to #0
     

    Attached Files:

Thread Status:
Not open for further replies.