Dismiss Notice
We would like to remind you that we’re updating our login process for all 3CX forums whereby you will be able to login with the same credentials you use for the Partner or Customer Portal. Click here to read more.

Dial tone provisioning help needed

Discussion in '3CX Phone System - General' started by spuddie, Sep 4, 2014.

Thread Status:
Not open for further replies.
  1. spuddie

    Joined:
    Sep 3, 2014
    Messages:
    10
    Likes Received:
    0
    Hi everyone

    I'm looking for a little guidance, I've been putting together an xml file with all the provisioning info we need for the Cisco SPA02G, the very last one I'm stuck on and can't find where to add 4 dial tone options which go under the Regional Tab then Call Progress Tones.

    I've tried to guess adding the below in but no luck:

    <Dial_Tone="Regional/Call Progress Tones">420@-19,520@-19;10(*/0/1+2)</Dial_Tone>
    <Outside_Dial_Tone="Regional/Call Progress Tones">350@-19,440@-19;10(*/0/1+2)</Outside_Dial_Tone>
    <Busy_Tone="Regional/Call Progress Tones">400@-10; 10(0.375/0.375/1)</Busy_Tone>
    <Ringback_Tone="Regional/Call Progress Tones">440@-19,480@-19;*(2/4/1+2)</Ringback_Tone>

    Is anyone able to help?

    Thanks
     
  2. NickD_3CX

    NickD_3CX Support Team
    Staff Member 3CX Support

    Joined:
    Jun 2, 2014
    Messages:
    1,379
    Likes Received:
    84
    Hi there,

    It might be worth having a look the Administration Manual for the Cisco phone which could contain this information, however I feel that this question would be more easily answered on the Cisco forum.
     
Thread Status:
Not open for further replies.