Displayfusion's "Toggle Window Always on Top" doesn't hold for 3CX when making or transferring a cal

Discussion in 'Windows' started by datalore, Apr 11, 2016.

Thread Status:
Not open for further replies.
  1. datalore

    Joined:
    Jun 26, 2012
    Messages:
    4
    Likes Received:
    0
    Hi,

    A niggly little issue.

    I set Shift+Z in DisplayFusion Settings - Functions - Window Management - "Toggle Window Always on Top", and apply this setting.

    I open 3CX (http://downloads.3cx.com/downloads/3CXP ... dows14.msi) and press Shift+Z and the window stays on top off all other windows.

    However, after I dial a number and when I press the "call" button, the setting to stay on top is lost, and I need to reapply it. the same goes for the "transfer" button (same location in the app, and comes up when I pick up a call and need to transfer it to someone else).

    Note that dialing a number does not affect this setting - it seems only on "call", "transfer", "end call" - basically any button located at the bottom of the app.

    Wondering if you had any thoughts or if this could be fixed?

    Regards,
    Stephen
     

    Attached Files:

  2. datalore

    Joined:
    Jun 26, 2012
    Messages:
    4
    Likes Received:
    0
  3. datalore

    Joined:
    Jun 26, 2012
    Messages:
    4
    Likes Received:
    0
    Response from Displayfusion last week:

    So, is 3CX modifying some "topmost property" when the buttons on the bottom of the app are pressed?
     
  4. datalore

    Joined:
    Jun 26, 2012
    Messages:
    4
    Likes Received:
    0
    Just "bumping" this again to see if anyone at 3CX can suggest a solution?
     
Thread Status:
Not open for further replies.