Fanvil X6 Hardware v1.1 - official Support

Discussion in '3CX Phone System - General' started by Michael L., Jan 6, 2018.

Thread Status:
Not open for further replies.
  1. Michael L.

    Joined:
    Jan 3, 2018
    Messages:
    2
    Likes Received:
    1
    From what I gathered from the forums, only Hardware version 1.2 of the Fanvil X6 is officially supported by 3CX. Is that correct? Will there be support for Hardware v1.1 at a later time?

    I just ordered a Fanvil X6 and received v1.1. If there is and will be no support, I will have to get it replaced.
     
  2. Chris-MBN

    Joined:
    Dec 22, 2017
    Messages:
    8
    Likes Received:
    1
    Michael,

    I doubt the v1.1 models will ever be supported. It has been a train wreck since it was released. We returned our v1.1 X6 models for v1.2 models. I suggest you do the same.
     
    NickD_3CX likes this.
  3. Stevetritton

    Joined:
    Aug 3, 2017
    Messages:
    14
    Likes Received:
    1
    Hi Michael

    I confirm what Chris has said. Have managed to change all 1.1 hardware version to 1.2 by processing RMA with distributor.
     
    NickD_3CX likes this.
  4. Michael L.

    Joined:
    Jan 3, 2018
    Messages:
    2
    Likes Received:
    1
    Thank you for your replies.
     
    NickD_3CX likes this.
  5. mtech1

    Joined:
    Jan 25, 2010
    Messages:
    28
    Likes Received:
    5
    We did the same, Fanvil Support authorised it and the UK disti advanced replaced them for us. Version 1.2 are better. They behave the same as the X4
     
    NickD_3CX likes this.
Thread Status:
Not open for further replies.