force DTMF to RTP

Discussion in '3CX Phone System - General' started by ksantella, May 10, 2007.

Thread Status:
Not open for further replies.
  1. ksantella

    Joined:
    Apr 23, 2007
    Messages:
    23
    Likes Received:
    0
    Is there a way to not process any in band dtmf? It seems as though I am getting these inbound and outbound and if after a call resolves and I hit a key it will show RTP and turn off in band dtmf (in the sever event log). This is a holdover issue from a previous post here about periodic beeping.

    The beeps are all listed in the server event log (both inbound and outbound) and are shown below for diag purposes.

    14:16:27.950 MediaServerReporting::DTMFhandler from 'dylanpbx:0/MediaServer':DTMF (in-band) from 207.174.202.4:10220 detected.
    14:15:26.512 MediaServerReporting::DTMFhandler from 'dylanpbx:0/MediaServer':DTMF (in-band) from 192.168.1.6:16466 detected.
    14:15:26.419 MediaServerReporting::DTMFhandler from 'dylanpbx:0/MediaServer':DTMF (in-band) from 192.168.1.6:16466 detected.
    14:15:21.528 CallLegImpl::eek:nConnected Call(C:11): Created audio channel for Ln:1200@Teliax (207.174.202.4:10220) with Media Server (71.251.126.83:9024)
    14:15:21.512 StratInOut::eek:nConnected Call(C:11): Setup completed for call from Ext.301 to Ln:1200@Teliax
    14:15:21.512 CallLegImpl::eek:nConnected Call(C:11): Created audio channel for Ext.301 (192.168.1.6:16466) with Media Server (192.168.1.2:7032)

    If I hit a key sending DTMF via RTP this is what occurs:
    15:46:56.434 MediaServerReporting::DTMFhandler from 'dylanpbx:0/MediaServer':DTMF (RTP) from 192.168.1.6:16480 arrived. in-band DTMF tone detection is turned off.

    where 192.168.1.6 is a linksys 942 and 192.168.1.2 is the pbx server on win2k3R2

    advice?
     
  2. ksantella

    Joined:
    Apr 23, 2007
    Messages:
    23
    Likes Received:
    0
    resolved!

    Hey all,

    found that removing the binding to media server stopped the dtmf beeping. By relinquishing the call control back to the voip itsp things are working well. I tried this with three itsp's and the beep is gone.

    Kevin
     
Thread Status:
Not open for further replies.