Dismiss Notice
We would like to remind you that we’re updating our login process for all 3CX forums whereby you will be able to login with the same credentials you use for the Partner or Customer Portal. Click here to read more.

FXS/FXO port and phones

Discussion in '3CX Phone System - General' started by Eliminateur, Nov 20, 2007.

Thread Status:
Not open for further replies.
  1. Eliminateur

    Joined:
    Nov 20, 2007
    Messages:
    1
    Likes Received:
    0
    Hello,
    i have some Micronet SIP FXS+FXO gateways and i wanted
    to know if 3cx product can handle a hybrid architecture with internal IP
    phones on one side and POTS phones connected to the FXS ports of the gateway(i.e: if the software can handle comms between POTS-IP phones and from POTS-gateway-PSTN comms).

    Can it also handle a complete POTS solution in which no-ip phones are
    present and a FXS gateway acting as bridge(POTS-PBX replacement/migration
    scenario which several customers present when changing to voip / ATA adapters).

    thanks in advance
     
  2. jb

    jb

    Joined:
    Nov 22, 2007
    Messages:
    5
    Likes Received:
    0
    Yes, should be no problem.

    Here's the 3CX config guide for some Micronet gateways.

    http://www.3cx.com/voip-gateways/Micronet-SP5050.html

    As far as 3CX is concerned the FXS phones are the same as any other IP phone extension - provided the Micronet is setup properly.
     
Thread Status:
Not open for further replies.