Grandstream GXW4108 firmware V1.3.4.10

Discussion in '3CX Phone System - General' started by edujim, Apr 7, 2012.

Thread Status:
Not open for further replies.
  1. edujim

    Joined:
    Apr 6, 2012
    Messages:
    19
    Likes Received:
    0
    I setup the Grandstream GXW4108 following the configuration guide, i also manually typed the Authentication password in channels section (step 5) of device configuration , I get the following errors on all ports except PORT 1 - which is Trunk 10000, submit, reboot (passwords supposed to be blank?) seems odd.

    step 10, outgoing rule, did this also with 0, doesnt seem to work, have to put a 9 and strip 1 digit then it works....


    12:23:48.848 [CM102001]: Authentication failed for SipReq: INVITE 10000@192.168.0.20 tid=8ef5c5020f940e30 cseq=INVITE contact=10007@192.168.0.150:5074 / 21184 from(wire); Reason: Credentials don't match, check that authorization-ID and password match the ones in extension settings


    12:23:30.599 [CM102001]: Authentication failed for SipReq: INVITE 10000@192.168.0.20 tid=ca62922402b23ef2 cseq=INVITE contact=10006@192.168.0.150:5072 / 11504 from(wire); Reason: Credentials don't match, check that authorization-ID and password match the ones in extension settings

    I tried a new topic earlier but it didnt work when i submitted! (seemed like a thesis) hope this enough info.

    Thanks
    EJ
     
  2. leejor

    leejor Well-Known Member

    Joined:
    Jan 22, 2008
    Messages:
    10,861
    Likes Received:
    302
    Are you setting up the gateway as one with multiple trunk groups, or one with one group, multiple trunk members?
     
  3. edujim

    Joined:
    Apr 6, 2012
    Messages:
    19
    Likes Received:
    0
    leejor thanks for the reply...

    I'm guessing it's (1) PSTN gateway with multiple trunk groups. That's what it seems like on the configuration guide.
    http: //www.3cx.com/voip-gateways/Grandstream-GXW-41044108 - NO LONGER AVAILABLE, (followed it step by step)

    But I could be wrong.. I'm fairly new to this to be honest.. I'm coming from the Cisco UCM world.. go figure! im installing 3CX at my friends business. (1. 3cx is good,farily easy, affordable, all in one package 2. cisco is damn expensive amongst other bad things.

    Thanks
    EJ
     
  4. edujim

    Joined:
    Apr 6, 2012
    Messages:
    19
    Likes Received:
    0
    going to try this again by removing passwords. on 3cx and grandstream.. just to test tomorrow..

    i will keep you posted.. i need to get this thing going asap.

    thanks again!
     
  5. GSSupport43

    Joined:
    Apr 16, 2012
    Messages:
    1
    Likes Received:
    0
    Hi,

    Could you please check once you configure and reboot the device that all the accounts are registered correctly from the status page of the GXW-410x ?

    Best Regards,
    GSSupport
     
Thread Status:
Not open for further replies.