Dismiss Notice
We would like to remind you that we’re updating our login process for all 3CX forums whereby you will be able to login with the same credentials you use for the Partner or Customer Portal. Click here to read more.

Has anyone used the Cisco SPA3000

Discussion in '3CX Phone System - General' started by terrys, Dec 28, 2017.

Thread Status:
Not open for further replies.
  1. terrys

    Joined:
    Nov 20, 2014
    Messages:
    7
    Likes Received:
    0
    I have a customer who needs to use one POTS line. Has anyone used the Cisco SPA3000 for an FXO??
     
  2. eddv123

    eddv123 Well-Known Member

    Joined:
    Aug 15, 2017
    Messages:
    1,400
    Likes Received:
    186
    Others on this forum have been setting these up, and 3CX used to have a manual setup guide dedicated to this device range however it has been removed - as you are probably aware these devices are un-supported.

    Either way you will need to set the device up in 3CX as a "Generic" Gateway, select the amount of lines you wish to use and main trunk number and setup the Cisco manually to register to 3CX.

    A little more work than a fully supported gateway like a Patton or beroNet but you should be able to achieve it.
     
  3. sip.bg

    sip.bg Active Member

    Joined:
    Nov 7, 2016
    Messages:
    704
    Likes Received:
    220
    You can configure it manually, it is very similar to SPA-3102 (f you find guides for it). Just create a custom gateway into your 3CX.
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
Thread Status:
Not open for further replies.