Incoming calls / Extension question

Discussion in '3CX Phone System - General' started by Spyklee, Jun 18, 2008.

Thread Status:
Not open for further replies.
  1. Spyklee

    Nov 1, 2007
    Likes Received:

    I've the following configuration
    - Patton 4554 with two ISDN lines
    - 3CX server (Small Business Edition)
    - Several LinkSys SPA942

    I've configured a LinkSys SPA942 as extension #102
    and fully configured Ext 1 on the LinkSys Ext 2 -- Ext 4 are only set to line enabled: yes

    Let's say make an outbound phone call ... any new incoming calls are not shown on the LinkSys.
    What are the specific settings I need to set, so I'm able to receive an incoming call although I'm having single/or multiple active calls (on hold).

    Cheers! Eric
Thread Status:
Not open for further replies.