Dismiss Notice
We would like to remind you that we’re updating our login process for all 3CX forums whereby you will be able to login with the same credentials you use for the Partner or Customer Portal. Click here to read more.

IP address change on SBC

Discussion in '3CX Phone System - General' started by Heath, Aug 26, 2017.

Thread Status:
Not open for further replies.
  1. Heath

    Heath New Member

    Joined:
    Aug 12, 2017
    Messages:
    122
    Likes Received:
    0
    how do you change either the primary or failover IP address in the SBC
     
  2. eddv123

    eddv123 Well-Known Member

    Joined:
    Aug 15, 2017
    Messages:
    1,441
    Likes Received:
    189
    Hi Heath,

    Is this on Linux, Raspberry pi or Windows SBC variants ?
     
  3. Heath

    Heath New Member

    Joined:
    Aug 12, 2017
    Messages:
    122
    Likes Received:
    0

    It's running on windows
     
  4. eddv123

    eddv123 Well-Known Member

    Joined:
    Aug 15, 2017
    Messages:
    1,441
    Likes Received:
    189
    Hi Heath,

    I only really use the Linux and Raspberry Pi variants (no licencing required), however from my experience I think you would be best off simply re-installing it with the desired credentials.

    Just use add remove programs and run the installer again, should not take a couple of minutes. However the phones will require a reset and re-provision if using a preferred phone model which supports PnP Provisioning.
     
Thread Status:
Not open for further replies.