Is there a way to terminate a call from the server?

Discussion in '3CX Phone System - General' started by Ralph, Jul 27, 2007.

Thread Status:
Not open for further replies.
  1. Ralph

    Ralph Member

    Joined:
    Jun 28, 2007
    Messages:
    417
    Likes Received:
    0
    Lets say you need to terminate a call from the server. Is there a way to do this?

    Thanks again
     
  2. 5qg4

    5qg4 Active Member

    Joined:
    Jan 31, 2007
    Messages:
    643
    Likes Received:
    0
    Restart "3CX PhoneSystem" service at your server.
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  3. SY

    SY Well-Known Member
    3CX Support

    Joined:
    Jan 26, 2007
    Messages:
    1,825
    Likes Received:
    2
    If you will restart 3CX PhoneSystem, then you need to restart "3CX PhoneSystem Media Server" as well if there were active calls.

    You may use CA to drop calls related to extension.
    DR will drop calls after timeout.

    Why do you need to drop those calls?
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  4. Ralph

    Ralph Member

    Joined:
    Jun 28, 2007
    Messages:
    417
    Likes Received:
    0
    Hi

    I had a situation where a call remained active even after the parties hung up. I think it had to do with one of them being on a wireless phone that was out of range of the base station and having dialed the 3cx pbx instead of an outside number by mistake. Anyhow, things happen and it would be good to have a way to take care of this without having to restart the entire server.
     
Thread Status:
Not open for further replies.