LAN CONNECTION SPEED

Discussion in '3CX Phone System - General' started by cverrall, Jan 28, 2009.

Thread Status:
Not open for further replies.
  1. cverrall

    Joined:
    Jan 26, 2009
    Messages:
    3
    Likes Received:
    0
    PATTON SMARTNODE 4114 & NETGEAR DG834T ROUTER.

    THERE IS AN AMBER LIGHT ON THE ROUTER AND THE 100M LIGHT ON THE SMARTNODE IS OFF, BOTH OF WHICH INDICATES CONNECTION AT REDUCED SPEEDS. DOES THIS EFFECT THE OPERATION TO ANY SIGNICANT DEGREE AND HOW TO CORRECT IT. MANY THANKS COLIN
     
  2. discovery1

    discovery1 Member

    Joined:
    Aug 4, 2008
    Messages:
    355
    Likes Received:
    0
    Check the cable between the two devices and replace it so see if it is the problem.

    You may be able to manually set the port speed on either the 4114 or the DG834T (or both) to 100M full duplex by using the web interface.
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  3. cverrall

    Joined:
    Jan 26, 2009
    Messages:
    3
    Likes Received:
    0
    Fixed. port speed on Patton 4114 smartnode defaults to 10 m half duplex. many thanks
     
Thread Status:
Not open for further replies.