Linksys PAP2T

Discussion in '3CX Phone System - General' started by wlt7913c, Feb 8, 2013.

Thread Status:
Not open for further replies.
  1. wlt7913c

    Joined:
    Jul 11, 2010
    Messages:
    4
    Likes Received:
    0
    I am using a Linksys PAP2T device as an extension. I have created an extension and successfully registered Line 2 and can make and receive calls. The problem I have is when I go to create another extension I cannot use the same device because of the MAC address. So how do I register the other line as an extension?
     
  2. mixig

    mixig Active Member

    Joined:
    Dec 13, 2011
    Messages:
    519
    Likes Received:
    11
    PAP2T is ATA right? You can normally configured two extension on that device, if you put mac address of PAP2T under the extension settings remove it, you dont need to put mac address, you are not doing provisioning via 3cx in this case
     
  3. wlt7913c

    Joined:
    Jul 11, 2010
    Messages:
    4
    Likes Received:
    0
    Well it won't let me remove that information, so I will delete the extension, and not provide provisioning information and see what happens... Yep that did the trick, complete brain fart on my end regarding the provisioning. thanks
     
Thread Status:
Not open for further replies.