Dismiss Notice
We would like to remind you that we’re updating our login process for all 3CX forums whereby you will be able to login with the same credentials you use for the Partner or Customer Portal. Click here to read more.

linksys spa921

Discussion in '3CX Phone System - General' started by techworx, Jul 26, 2008.

Thread Status:
Not open for further replies.
  1. techworx

    Joined:
    Jul 22, 2008
    Messages:
    17
    Likes Received:
    0
    when i pick up the phone ,if i dont dial in 1 sec it goes to an engaged tone,is there a setting in the linksys config to make this a bit longer?
     
  2. ess

    ess New Member

    Joined:
    Jun 8, 2007
    Messages:
    133
    Likes Received:
    0
    please refer to the following post:

    http://www.3cx.com/forums/time-out-when-dialing-5949.html#p28431

    it discusses the issue in detail.
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  3. techworx

    Joined:
    Jul 22, 2008
    Messages:
    17
    Likes Received:
    0
    Hi Thanks for the reply,when i click on the link ,i get this message "You are not authorised to read this forum."
     
  4. ess

    ess New Member

    Joined:
    Jun 8, 2007
    Messages:
    133
    Likes Received:
    0
    Sorry, I just wasn't thinking when I linked that thread.

    Here is a recap of the relevant posts in that thread:

    From Me:

    From kevin:

    From Jparisi
    From ra81:

    So, if you're using a free version, the provisioning update does not help you much. However, you can mess with those inter digit timeouts to try and find a balance (acceptable delay).
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
Thread Status:
Not open for further replies.