Low volume linksys spa3102 & caller id voipbuster

Discussion in '3CX Phone System - General' started by carmico, Dec 18, 2007.

Thread Status:
Not open for further replies.
  1. carmico

    Joined:
    Oct 11, 2007
    Messages:
    23
    Likes Received:
    0
    1. How to setup the conversation's volume on linksys spa3102 as pstn line gateway ?--- because is too low.

    1.1 How to setup the music-on-hold volume on 3cx? because is too high..

    2. how to setup the outgoing call caller id for voipbuster? i set in 3cx the outgoing ID but doesn't work, still private id.

    thanks,
    Carlo
     
  2. miraportuga

    miraportuga Member

    Joined:
    Aug 7, 2007
    Messages:
    297
    Likes Received:
    0
    Hi, about your 1 question, log into your SPA has admin, go the pstn line configuration, on the bottom you will see SPA to PSTN and PSTN to SPA gain, change those values to get higher or lower volume, be careful thoug, if this values are too high it can create echo during conversations.

    Question 2, has far has i know, not possible

    Question 3, has far has i know, not possible either....

    Cheers
     
  3. subh

    Joined:
    Dec 4, 2007
    Messages:
    28
    Likes Received:
    0
    For Q2 --> open the on-hold music file in a wave editor and lower the volume and save it as another file. Use that new file as your on-hold music.

    Hope this helps.
     
  4. carmico

    Joined:
    Oct 11, 2007
    Messages:
    23
    Likes Received:
    0
    yes, thanks for the solutions!!!
     
Thread Status:
Not open for further replies.