Making Calls with SPA3102

Discussion in '3CX Phone System - General' started by alexMV, Aug 29, 2008.

Thread Status:
Not open for further replies.
  1. alexMV

    Joined:
    Aug 29, 2008
    Messages:
    1
    Likes Received:
    0
    Hi everyone...

    We are toying with an idea of replacing our aging propriotary PBX with 3CX. My current test envoroment is:


    3CX version 6
    2 - Linksys SPA921
    1 - Linksys SPA3102

    I'm able to make calls from extension to extension, that works great
    I connected SPA3102 to POTS line to make outgoing calls

    my config looks like this

    3CX server 192.168.6.8
    SPA921-1 192.168.6.9
    SPA921-2 192.168.6.10
    SPA3102 192.168.6.12 (wan port) (lan port is default)

    I have an outbound rule in place
    RULE NAME: PSTN1
    APPLY TO EXTENSIONS: 100-110
    ROUTE 1 - PSTN1

    When I look into Server status i see he following entries:
    [CM503003]: Call(5): Call to sip:5555555555@192.168.6.12:5060 has failed; Cause: 404 Not Found; from IP:192.168.6.12:5060

    [CM503015]: Call(5): Attempt to reach [sip:5555555555@192.168.6.8] failed. Reason: Not Found

    [CM503008]: Call(5): Call is terminated

    (5555555555 -< is the numner i'm trying to dial)

    Line status says:
    PSTN Lines
    10000 Line No: 10000
    Status: Registered (idle

    Any help is greatly appriciated
    Alex
     
  2. amygoda

    amygoda Member

    Joined:
    Sep 18, 2006
    Messages:
    436
    Likes Received:
    0
    Hello Alex,
    Change port from 5060 to 5061 o server and spa3102

    then read this posts and if you found it good support it

    http://www.3cx.com/forums/edit-spa3102-configuration-6634.html

    http://www.3cx.com/forums/add-new-ext-6636.html#p34671
     
Thread Status:
Not open for further replies.