Manual fax using Yeastar TA200

Discussion in '3CX Phone System - General' started by Bryan Nightingale, Feb 21, 2018.

Tags:
Thread Status:
Not open for further replies.
  1. Bryan Nightingale

    Joined:
    Feb 20, 2018
    Messages:
    1
    Likes Received:
    0
    I am trying to set up manual fax using TA200. I have configured everything and I'm able to make voice calls. However I can not get the sending and receiving of faxes to work. Any ideas on what I may have done wrong. I'm using 3CX v15.
     
Thread Status:
Not open for further replies.