Multi-Port routing configuration

Discussion in '3CX Phone System - General' started by cfive, Dec 21, 2009.

Thread Status:
Not open for further replies.
  1. cfive

    cfive Member

    Joined:
    Aug 20, 2009
    Messages:
    284
    Likes Received:
    6
    Hi,

    Using 3cx v8.x, and Patton 4 port FXO (2).

    When configuring the ports on the Pattons, it seems that one must configure each of the 4 ports on the devices individually. Where the configuration for all 4 is the same - i.e. all connect to the same DR for office hours, and all connect to the same DR for out of office hours - it's a PITA to have to do this for every port. That's 8 configs for 8 ports, all the same routing.

    Is there a way to apply the config to all ports at once?

    Thanks - Les.
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  2. cfive

    cfive Member

    Joined:
    Aug 20, 2009
    Messages:
    284
    Likes Received:
    6
    This was resolved by directing all incoming calls to an extension, on a tip provided by Kerry G. The forwarding rules for the extension can be used to route calls beyond.

    In this way, the ports never need changing, they always route to the extension :).

    Thanks, Kerry

    - Les.
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
Thread Status:
Not open for further replies.