Multiple Sidecars on Yealink T46S

Discussion in '3CX Phone System - General' started by jbryant84, Jul 26, 2017.

Thread Status:
Not open for further replies.
  1. jbryant84

    jbryant84 New Member

    Joined:
    Apr 6, 2016
    Messages:
    106
    Likes Received:
    38
    I can't figure out how to get BLFs to display on more than one sidecar on these phones. Previously we had Cisco SPA-504s, and 32 was the last button on the first sidecar, so 33 was the first button on the second sidecar. On Yealink T46Ss the first sidecar starts at 26, and there are two pages of 20 buttons each, so logic dictates that 66 would be the first button of the the second sidecar. I have one client that has BLFs up to the 70s, but anything after 65 disappears, the second sidecar is blank. We are using V15.5, latest supported firmware on the phones.
     
  2. CentrexJ

    CentrexJ Member

    Joined:
    May 5, 2009
    Messages:
    385
    Likes Received:
    52
    I believe if you want to use the 3CX template for a second sidecar you have to customize the template.
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
Thread Status:
Not open for further replies.