Outbound CallerID using MakeCALL

Discussion in '3CX Phone System - General' started by dannybrook, May 6, 2011.

Thread Status:
Not open for further replies.
  1. dannybrook

    Joined:
    Feb 24, 2010
    Messages:
    43
    Likes Received:
    0
    According to 3CX this is by design, so I'm curious if anyone else has experienced this before...

    Scenario:

    Sangoma A101 connected to a SIP-delivered PRI (Telepacific Smartvoice)
    Using the MakeCall function and the outbound callerid displayed on the phone I'm calling says only the area code, which is the only thing my provider can send if I don't send any callerid.

    Is there anyway to make the MakeCall function send out callerid or possibly work around it using the NetBorderExpress to send out callerid if 3CX does not.
     
  2. smb1

    smb1 New Member

    Joined:
    Mar 18, 2009
    Messages:
    104
    Likes Received:
    0
    Have you set a caller ID on the VOIP provider settings?
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  3. dannybrook

    Joined:
    Feb 24, 2010
    Messages:
    43
    Likes Received:
    0
    David,

    I am using a Sangoma A101 PRI...no voip provider. There is an outbound callerid set for the Sangoma, but it does not work if the call originates from the "MakeCall" function.
     
Thread Status:
Not open for further replies.