Dismiss Notice
We would like to remind you that we’re updating our login process for all 3CX forums whereby you will be able to login with the same credentials you use for the Partner or Customer Portal. Click here to read more.

Outbound calling using MV372 GSM Gateway

Discussion in '3CX Phone System - General' started by onestopit, Aug 16, 2007.

Thread Status:
Not open for further replies.
  1. onestopit

    Joined:
    Aug 8, 2007
    Messages:
    11
    Likes Received:
    0
    Hi folks,



    I'm trying to configure outbound call routing using the MV372 GSM gateway device (http://www.pulsewan.com/voip/mv372_search.htm) but not getting anywhere with the following errors:



    19:56:29.953 CallConf::Rejected [CM103005] Call(13) is rejected: Destination is busy

    19:56:29.953 StratInOut::eek:nCancel [CM104008] Call(13): Call from Ext.100 to <mymobilenumber> terminated; cause: 486 Busy Here; from IP:10.10.10.221

    19:56:28.875 CallConf::eek:nIncoming [CM103002] Call(13): Incoming call from 100 (Ext.100) to sip:,<mymobilenumber>@10.10.10.11





    Any ideas???



    Inbound routing works fine.... just the outbound bit is the problem.
     
  2. Costas3CX

    Costas3CX New Member

    Joined:
    Jan 23, 2007
    Messages:
    217
    Likes Received:
    0
    Hello

    Have you looked at the manual to see how you are supposed to configure outbound rules?

    Make sure you set a prefix number which forwards calls to your gateway/provider and a transform mask that deletes it. Then make sure you dial that digit before you mobile number

    Regards
     
  3. super_voip

    Joined:
    Aug 29, 2007
    Messages:
    20
    Likes Received:
    0
    mobile numbers

    Our mobile numbers start with the country code and don't have the 1st zero of the number eg +61418xxxxx. It is the mobile companies that make the number easier to read eg 0418xxxxx
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
Thread Status:
Not open for further replies.