Outgoing Line Priority

Discussion in '3CX Phone System - General' started by mdmattingly, May 5, 2011.

Thread Status:
Not open for further replies.
  1. mdmattingly

    Joined:
    May 5, 2011
    Messages:
    1
    Likes Received:
    0
    We are running the 3cx phone system with a Patton Smartnode 4110 gateway. When we place a phone call, it uses the fourth line on the gateway first and the hunts back to the first one if that is taken. Is there a way for us to configure either the gateway itself or the 3cx software so that it dials out on the first port instead of the last one when no other lines are in use? The last one is also the fax number so we would rather leave that free as much as possible without shutting off outgoing calls on it all together.

    Thanks
     
  2. davidbenwell

    davidbenwell Active Member

    Joined:
    Apr 27, 2010
    Messages:
    704
    Likes Received:
    0
    Not used the Patton Smartnode 4110 gateway as of yet, but do you have the option to set each line with its own username and password, if so, you could seperate them and then apply outbound rules within 3CX
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
Thread Status:
Not open for further replies.