Patton 4112 Configuration

Discussion in '3CX Phone System - General' started by dnut, Mar 23, 2017.

Tags:
Thread Status:
Not open for further replies.
  1. dnut

    Joined:
    Dec 19, 2016
    Messages:
    10
    Likes Received:
    0
    Hello,
    I'm not able to make this gateway up and running.

    I followed the instructions here: https://www.3cx.com/voip-gateways/patton-smartnode-sn4112/

    I firstly upgraded Patton 4112 to the last available firmware
    Then configured SIP Trunk as explained in the guide
    I loaded the config file in the Patton
    Then I configured a generic outbound rule.

    I'm able to receive calls, but unable to make an outbound call.

    Any idea?

    Thank you for the support

    Here the screenshot of the configurations: https://goo.gl/photos/zNq6kar7DxB2WaYH6

    Here the log of a single call attempt (also attached here): https://drive.google.com/file/d/0BxXe6dpaQIPqeHQ4Vmc0bG55dDA/view?usp=sharing
     

    Attached Files:

  2. JasonNadeau

    JasonNadeau Member

    Joined:
    Oct 14, 2015
    Messages:
    262
    Likes Received:
    46
    Can we get the config file you're using in the patton as well please ?
    ... might need you to SSH in to the patton and turn on fxo debugging :
    enable
    configure
    debug ccfxo
    debug fxo
    debug call-control
    debug call-router
    debug context sip-gateway transport
    debug context sip-gateway error

    ... don't forget to turn off debugging (if you turn it on) : no debug all
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
Thread Status:
Not open for further replies.