Patton 4114 FXO

Discussion in '3CX Phone System - General' started by RSAS, Nov 23, 2013.

Thread Status:
Not open for further replies.
  1. RSAS

    Joined:
    Nov 17, 2013
    Messages:
    3
    Likes Received:
    0
    Is there any way to assigning a specific port to a specific phone or phone button . I know it assigned virtual extension ports but I cannot figure out how to do this. I tried outbound rules but it only has a selection for the Patton it does not breakout by port.

    Thanks
    Rich
     
  2. leejor

    leejor Well-Known Member

    Joined:
    Jan 22, 2008
    Messages:
    10,758
    Likes Received:
    286
    You would have to set-up the gateway, so that each PSTN line (port) was a separate trunk group. Four groups with one member each rather than one trunk group with four members. Some gateways allow for this more simply than others, and may require manual provisioning. Once you've done this you could then set-up outbound rules so that certain extensions would use certain trunks.
     
Thread Status:
Not open for further replies.