Patton 4114 FXO

Discussion in '3CX Phone System - General' started by ossiejnr, Feb 23, 2016.

Thread Status:
Not open for further replies.
  1. ossiejnr

    Joined:
    Feb 23, 2016
    Messages:
    4
    Likes Received:
    0
    Hi,

    I've got a Patton 4114 FXO gateway and I wish to set this up so that when outbound calls are made they are sent to specific lines and not just the first one that is available.

    I believe I can do this by adding 4 different Gateways with different virtual extensions and then basically merging the generated configs in to one and uploading this to the Patton. I'm wondering if anybody has done this and can share a config or point me in the direction of a way to achieve this? Otherwise I'll roll up my sleeves and give it a go and see if I can get it working....

    Thanks
     
  2. AlexanderHanna

    Joined:
    Oct 2, 2015
    Messages:
    89
    Likes Received:
    11
    Here you go, this works for me.
     

    Attached Files:

  3. ossiejnr

    Joined:
    Feb 23, 2016
    Messages:
    4
    Likes Received:
    0
    That is ace - thank you so much
     
  4. bob222

    Joined:
    Oct 3, 2015
    Messages:
    23
    Likes Received:
    1
    Thank you AlexanderHanna. This worked perfectly for me and I didn't fry my brain trying to figure it out myself.
     
Thread Status:
Not open for further replies.