Patton 4120 Stripping Leading 0 on Inbound Calls

Discussion in '3CX Phone System - General' started by shiva, Sep 24, 2012.

Thread Status:
Not open for further replies.
  1. shiva

    Joined:
    Oct 12, 2010
    Messages:
    6
    Likes Received:
    0
    Hi

    We're using a Patton 4120 ISDN gateway. We have a fully working system, however on inbound calls the leading 0 is stripped by the Patton gateway, hence caller IDs are displayed without 0. What do I nned to do to get the 0 to display in caller IDs?
     
  2. 3CXfoxhallsolutions

    3CXfoxhallsolutions New Member

    Joined:
    Sep 8, 2012
    Messages:
    211
    Likes Received:
    0
    This is common on most Patton analogue & ISDN gateways, and can be fixed very quickly ...

    Log onto the IP address of the gateway with your browser ...
    In the 'Telephony' section, choose the 'Call-Router' link.
    Select the 'Configuration' tab.
    Scroll to the bottom and you'll see the E.164 Number Prefixes section ...
    Tick the two boxes for national & International Prefixes, and then select the green tick to the right to apply the change.
    Save the configuration ...

    Incoming calls will then show the leading zero on your phone display.
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  3. shiva

    Joined:
    Oct 12, 2010
    Messages:
    6
    Likes Received:
    0
    Thanks Graham
     
Thread Status:
Not open for further replies.